Neighbor Distribute-List - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

neighbor distribute-list

neighbor { ipAddress | ipv6Address | peerGroupName } distribute-list
Syntax
accessListName { in | out }
no neighbor { ipAddress | ipv6Address | peerGroupName } distribute-list
[ accessListName ] { in | out }
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
Distributes BGP neighbor information as specified in an access list. The no version
Description
removes an entry.
Using distribute lists is one of several ways to filter BGP advertisements. You can
also use route maps or use AS-path filters, as with the ip as-path access-list Global
Configuration command and the neighbor filter-list command.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor
peerGroupName Name of a BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command, unless it is overridden for a
specific peer.
accessListName String of up to 32 alphanumeric characters identifying an access
list
in Applies list to incoming routes (inbound policy)
out Applies list to outgoing routes (outbound policy); you cannot configure a
member of a peer group to override the inherited peer group characteristic for
outbound policy
Chapter 2: N Commands
37
neighbor distribute-list