Neighbor Allow - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

neighbor allow

[ no ] neighbor peerGroupName allow accessListName
Syntax
[ max-peers maxNumberDynamicPeers ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures the peer group so that it accepts inbound connections from any remote
Description
address that matches the access list. The no version removes the configuration.
Options
Router Configuration
Mode
28
neighbor allow
peerGroupName Name of a BGP peer group
accessListName Name of an access list that specifies remote addresses from
which BGP connections may be accepted
maxNumberDynamicPeers Maximum number of dynamic peers that a member
of the peer group may accept