Neighbor Advertise-Map - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

neighbor advertise-map

[ no | default ] neighbor { ipAddress | ipv6Address | peerGroupName }
Syntax
advertise-map advertiseMapName { exist-map | non-exist-map }
conditionMapName [ seq sequenceNumber ]
Command introduced in JUNOSe Release 9.0.0.
Release Information
Specifies a peer or peer group within the current address family to which routes
Description
specified by the first route map are advertised conditionally, depending on whether
the second route map is matched by some other routes in the BGP routing table. The
no version removes the conditions for advertising the routes to the peer or peer
group. The default version removes the explicit configuration from the peer or peer
group and reestablishes inheritance of the feature configuration.
Options
Address Family Configuration
Mode
26
neighbor advertise-map
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor
peerGroupName Name of a BGP peer group. If you specify a BGP peer group all
the members of the peer group inherit the characteristic configured with this
command
advertiseMapName Name of a route map that specifies the routes controlled by
conditional advertisement; no more than 50 advertise maps can be configured
per peer or peer group in an address-family
conditionMapName Name of a route map that specifies the routes that control
conditional advertisement
sequenceNumber Number, in the range 1–65535, that indicates the position an
advertise route map has in the list of advertise route maps configured for a
particular neighbor within the same address family; if the sequence number is
not specified, the position of the route map is considered to be the sum of the
current largest sequence number plus five