Module Types And Capabilities For Qos Cell Mode Application; Cell Tax Adjustment Using Qos Cell Mode; Table 27: Supported Interfaces For Qos-Shaping-Mode And Qos-Cell-Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual
Software for e series broadband services routers quality of service configuration guide
Table of Contents
Advertisement
JunosE 11.3.x Quality of Service Configuration Guide
Module Types and Capabilities for QoS Cell Mode Application
Cell Tax Adjustment Using QoS Cell Mode
266
The QoS administrator then applies frame shaping mode to the Gigabit Ethernet interface
configured on slot 6, adapter 0, port 2, subinterface 1 using the QoS cell mode application.
This parameter instance overrides the shaping mode configured at the port.
host1(config-if)#interface gigabitEthernet 6/0/2.1
host1(config-if)#qos-parameter cell-mode 0
The QoS cell mode application is supported by all E Series routers. However, different
module types support the application.
Table 27 on page 266 lists the supported modules for the qos-shaping-mode cell command
and the qos-cell-mode application for parameters. It also describes how the cell mode
adjustment is performed by each module type.
Table 27: Supported Interfaces for qos-shaping-mode and qos-cell-mode
Commands
qos-shaping-mode
Module Type
cell Command
Ethernet interfaces on
ES2 4G LM and ES2
10G LM (E120 and
E320 Broadband
Services routers)
Ethernet interfaces on
GE-2 and GE-HDE line
modules (ERX7xx
models, ERX14xx
models, and ERX310
routers)
Ethernet interfaces on
–
ERX7xx models,
ERX14xx models, and
ERX310 routers
ATM interfaces on all
E Series routers
All other interface
–
types on all E Series
routers
The internal cell-taxing mechanism does not perform the cell mode adjustment on certain
interface types. On these interfaces, the system uses a parameter expression associated
with the qos-cell-mode application to determine whether the cell adjustment is required.
qos-cell-mode
Adjustment
Application
Performed By
Internal cell-taxing
mechanism
Internal cell-taxing
mechanism
Parameter expression
associated with
qos-cell-mode
application (See "Cell
Tax Adjustment Using
QoS Cell Mode" on
page 266.)
–
Internal cell-taxing
mechanism
–
–
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 and is the answer not in the manual?