Path Ds3 Loopback - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

path ds3 loopback

path pathChannel ds3 ds3Channel loopback { local | network { line | payload } }
Syntax
no path pathChannel ds3 ds3Channel loopback
[ no ] path pathChannel ds3 ds3Channel loopback remote
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures a loopback at the DS3 layer for a DS3 signal. This command applies to a
Description
DS3 over channelized SONET interface. The no version turns off the loopback.
Options
Controller Configuration
Mode
pathChannel Number, in the range 1–2147483648, that identifies the path
ds3Channel Number, in the range 1–3, that identifies the path
local Loops the data back toward the router; on supported line modules also
sends an alarm indication signal (AIS) out toward the network.
network { line | payload } Specify the line keyword to loop the data toward
the network before the data reaches the framer. Specify the payload keyword
to loop the data toward the network after the framer has processed the data.
remote Sends a far end alarm code in the C-bit framing, as defined in
ANSI T1.404, to notify the remote end to activate or (when you use the no
version) deactivate the line loopback
Chapter 4: P Commands
157
path ds3 loopback