Path Ds1 Fdl - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

path ds1 fdl

path pathChannel ds1 tributaryIdentifier fdl { ansi | att | all | none }
Syntax
no path pathChannel ds1 tributaryIdentifier fdl [ ansi | att | all ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the FDL standard for a DS1 signal when DS1 is configured over a channelized
Description
SONET or SDH interface. The no version restores the default, none.
Options
Controller Configuration
Mode
146
path ds1 fdl
pathChannel Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload Payload number for the path; value is 1 for SONET and in the
range 1–3 for SDH
tributaryGroup Number, in the range 1–7, that identifies the group within
the path
tributaryNumber Number of the tributary within the tributary group; the
value is in the range 1–4 if the tributary type is vt15 or tu11 and in the range
1–3 if the tributary type is tu12
ansi Specifies ANSI T1.403 Standard for extended superframe FDL exchange
support
att Specifies AT&T Technical Reference 54016 for extended superframe FDL
exchange support
all Specifies both the AT&T and ANSI mode for extended superframe FDL
exchange support
none Removes the current FDL mode settings