Ospf Log-Adjacency-Changes - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

ospf log-adjacency-changes

[ no ] ospf log-adjacency-changes
Syntax
[ severity { severityValue | severityNumber } ] [ verbosity verbosityLevel ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures the router to send a system log message when the state of an OSPFv2
Description
neighbor changes. For OSPFv3 neighbors, use the log-adjacency-changes command.
The no version turns off this feature.
Options
Router Configuration
Mode
118
ospf log-adjacency-changes
severity Minimum severity of the log messages displayed for the selected
category; described either by a descriptive term severityValue or by a
corresponding number severityNumber in the range 0–7; the lower the number,
the higher the priority:
emergency or 0 System unusable
alert or 1 Immediate action needed
critical or 2 Critical condition exists
error or 3 Error condition
warning or 4 Warning condition
notice or 5 Normal but significant condition
info or 6 Informational message
debug or 7 Debug message
verbosityLevel Specifies the verbosity of the log category's messages; can be
any of the following:
low Terse
medium Moderate detail
high Verbose