Nsf T2 - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

nsf t2

[ no ] nsf t2 { level-1 | level-2 } [ seconds ]
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the maximum amount of time, in seconds, that an IS-IS restarting router
Description
waits for the LSP database to synchronize. You must configure separate instances
of the T2 timer for each IS-IS level at which the router operates. The no version
restores the default T2 wait time, 30 seconds.
Options
Router Configuration
Mode
level-1 Sets the T2 wait time independently for level 1 routing
level-2 Sets the T2 wait time independently for level 2 routing
seconds Maximum wait time, in the range 5–120 seconds, for LSP database
synchronization; default value is 30 seconds
Chapter 2: N Commands
95
nsf t2