Neighbor Send-Label - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

neighbor send-label

[ no ] neighbor { ipAddress | ipv6Address | peerGroupName } send-label
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
Configures a neighbor to distribute an MPLS label with its IPv4 and IPv6 route
Description
advertisements. This command enables BGP to dynamically negotiate SAFI 1 and
SAFI 4 with this neighbor. In Router Configuration mode, the command has the same
effect as if it were issued in the context of the IPv4 unicast address family. The no
version removes the configuration.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor
peerGroupName Name of a BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command. You cannot override the
characteristic for a specific member of the peer group.
Chapter 2: N Commands
63
neighbor send-label