Duplex; Flow-Control - H3C MSR 20-20 Command Reference Manual

168 C 8: G
HAPTER ENERAL

duplex

Syntax
View
Parameter
Description
Related command:
Example

flow-control

Syntax
View
E I C
THERNET NTERFACE ONFIGURATION
Table 12 Description on the fields of the display interface command (in bridge mode)
Field
Input (total):
Input (normal):
Input:
Output (total):
Output (normal):
Output:
duplex { auto | full | half }
undo duplex
Ethernet interface view
auto: Indicates that the interface is in an auto-negotiation state.
full: Indicates that the interface is in a full-duplex state.
half: Indicates that the interface is in a half-duplex state.
Use the command to configure the duplex mode for an Ethernet
duplex
interface.
Use the undo duplex
interface to the default.
By default, the duplex mode for an Ethernet interface is auto.
speed.
# Configure the interface Ethernet 1/0 to work in full-duplex mode.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] duplex full
flow-control
undo flow-control
Ethernet interface view
C
OMMANDS
Description
Error statistics on the interface inbound and
outbound packets, underscore indicates that the
corresponding entry is invalid
command to restore the duplex mode for an Ethernet