display dsl status
Syntax
View
Parameter
Description
Example
Rate(Bytes):
Rate(kbps):
Latency:
FEC(fast):
S/D/R(Inlv):
DMT Bits Allocation Per Bin (Up/Down Bits:249/2148)
00: 0 0 0 0 0 0 7 8 a a a a 8 a b c c c b b b b b b 9 9 a a 9 8 8 0
20: 0 0 0 0 2 2 2 3 4 4 5 6 6 7 7 8 8 8 8 8 9 9 a a a a a a a 8 9 a
40: 0 a a a a b b b b b a b b b b b b b b b b b b b b b b b b b b b
60: b b b b b b b b b b b b b b b b b b b a 9 4 a b b b b b b b b b
80: b b b b b b b b b b b b b b b b b b b b b b b b b b b b b b b b
a0: b b b a b a b a b b a b b b b b a a b a a b b a a a a a a a a a
c0: a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
e0: a 9 9 a 9 9 9 9 9 9 8 9 9 9 9 9 9 9 9 9 8 8 8 8 8 7 7 7 7 6 6 6
Table 4 Description on the fields of the display dsl configuration command
Field
Line Params Set by User
The following information appears after the line is activated.
Actual Config
Rate(kbps)
Latency
DMT Bits Allocation Per Bin
display dsl status interface atm interface-number
Any view
interface-number: Specifies a DSL interface to view the status information about.
Use the
display dsl status
specified DSL interface.
# Display the status information of the ADSL interface ATM 2/0.
<Sysname> display dsl status interface atm 2/0
Line Status:
Training Status:
Active Params
Standard:
SNR (dB):
Attn(dB):
Pwr(dBm):
AS0 (DS)
LS0(US)
238
26
7616
832
Intlv
Intlv
0
0
1/64/16
8/8/16
Description
Line parameters at ATU-R end, such as Standard, DMT
Mode, Framing, and Trellis Coding. Among these
parameters, you can only modify Standard for test or
diagnosis, but not the others.
Real operating parameters after the line is activated
Negotiation rate in kbps, with AS0 (DS) for the downlink
and LS0 (US) for the uplink
Latency mode: Fast or Interleave
Bits allocated to and carried by each bin.
command to display the status information of a
Loss Of Signal
Idle
Near End
Far End
G.dmt
G.dmt
0.0
0.0
0.0
0.0
0.0
0.0
147