ima-standard
Syntax
View
Parameter
Description
Example
ima-test
Syntax
View
Parameter
Description
ima-standard { alternate-v10 | normal | standard-v10 | standard-v11 }
undo ima-standard
IMA group interface view
alternate-v10: Uses V1.0 (other implementation) standard.
normal: Uses V1.1 standard. An IMA group interface adopting this standard
changes to adopt V1.0 (standard implementation) standard if its peer interface
adopts V1.0 (standard implementation).
standard-v10: Uses V1.0 (standard implementation) standard.
standard-v11: Uses V1.1 standard.
Use the
ima-standard
group interface.
Use the
undo ima-standard
By default, V1.1 standard is adopted.
# Configure to adopt V1.1 standard.
<Sysname> system-view
[Sysname] interface atm 5/0
[Sysname-Atm5/0] ima ima-group 1
[Sysname-Atm5/0] interface ima-group 5/1
[Sysname-Ima-group5/1] ima-standard standard-v11
ima-test [ link-number number ] [ pattern-id id ]
undo ima-test
IMA group interface view
link-number number: Specifies the number of the E1/T1 link to be tested.
pattern-id id: Specifies the test mode, a hexadecimal number in the range 0x00
to 0xFE.
Use the
command to specify the E1/T1 link to be tested and the test
ima-test
mode for IMA group interface test.
Use the
undo ima-test
command to set the standard to be adopted by an IMA
command to restore the default.
command to cancel the test.
119