Display Dsl Configuration - H3C MSR 20-20 Command Reference Manual

146 C 6: ADSL I
HAPTER
Example

display dsl configuration

Syntax
View
Parameter
Description
Example
C C
NTERFACE ONFIGURATION OMMANDS
Use the all keyword with caution. In case failure occurs, recovery is difficult and
troublesome.
Note that:
Only distributed devices support the slot slot-no-list option.
■
The subslot subslot-no-list option is not available if the device does not
■
support the sub-card-level maintenance.
# Upgrade software for an ADSL2+ card.
<Sysname> system-view
[Sysname]interface atm 2/0
[Sysname-Atm2/0]shutdown
[Sysname-Atm2/0] quit
[Sysname] quit
<Sysname> bootrom update file flash:/bcm6348.bin slot 1 part
This command will update BootRom file on board 2, Continue? [Y/N]y
Board 2 upgrading BOOTROM, please wait...
<Sysname> system-view
[Sysname]interface atm 2/0
[Sysname-Atm2/0]undo shutdown
display dsl configuration interface atm interface-number
Any view
interface-number: Specifies a DSL interface to view the configuration information
about.
Use the display dsl configuration
DSL interface.
# Display the actual configurations of ADSL interface ATM 2/0.
<Sysname> display dsl configuration interface atm 2/0
Line Params Set by User
Standard:
Annex:
Framing:
Coding Gain(dB):
Tx Pow Attn(dB):
Bit-Swap:
LinkCheck:
Actual Config
Standard:
Trellis Coding:
Framing:
Vendor ID:
command to display the configuration of a
T1.413
A
3
Auto
0
disable
Enable
Near End Far End
T1.413 T1.413
Enable Enable
3 3
0x0039 0x0004