Shdsl Annex; Shdsl Mode - H3C MSR 20-20 Command Reference Manual

shdsl annex

Syntax
View
Parameter
Description
Example

shdsl mode

Syntax
View
Parameter
Description
shdsl annex { a | b }
undo shdsl annex
ATM (G.SHDSL) interface view
a: Annex A.
b: Annex B.
Use the shdsl annex command to configure the annex standard supported on
the G.SHDSL interface. You cannot activate a link with different standard types at
its two ends.
Use the
undo shdsl annex
Annex A is dominant in North America while Annex B is dominant in Europe.
When setting annex standard, you must consider the standard adopted in the
region where your network is located. When ATU-C and ATU-R use different
standards, G.SHDSL cannot set up connection.
# Configure G.SHDSL interface ATM 5/0 to support annex A.
<Sysname> system-view
[Sysname] interface atm 5/0
[Sysname-Atm5/0] shdsl annex a
shdsl mode { co | cpe }
undo shdsl mode
ATM (G.SHDSL) interface view
co: Specifies the central office (CO) mode.
cpe: Specifies the customer premises equipment (CPE) mode.
Use the shdsl mode command to set the operating mode for a G.SHDSL
interface.
Use the
undo shdsl mode
By default, a G.SHDSL interface operates in CPE mode.
For a back-to-back connection, you need to configure one end to CO mode and
the other end to CPE mode.
command to restore the default, that is, Annex B.
command to restore the default.
137