Clock - H3C MSR 20-20 Command Reference Manual

7

clock

Syntax
View
Parameter
Description
Example
crc
Syntax
View
POS I
NTERFACE
C
OMMANDS
clock { master | slave }
undo clock
POS interface view
master: Sets the clock mode of the POS interface to master.
slave: Sets the clock mode of the POS interface to slave.
Use the command to set the clock mode of the POS interface.
clock
Use the undo clock command to restore the default, that is, slave.
POS interfaces support two clock modes:
Master, which uses internal clock signal.
■
Slave, which uses line clock signal.
■
Similar to the DTE/DCE model of synchronous serial interfaces, POS interfaces
need to choose a clock mode. When a POS interface on the router is directly
connected to another router, the only requirement is that the two sides use
different clock modes. In connection to a switch, however, the switch is DCE and
uses internal clock, so the POS interface is DTE and must adopt the slave clock
mode.
# Set the clock mode of interface POS 1/0 to master.
<Sysname> system-view
[Sysname] interface pos 1/0
[Sysname-Pos1/0] clock master
crc { 16 | 32 }
undo crc
POS interface view
C
ONFIGURATION