Frame-Format - H3C MSR 20-20 Command Reference Manual

124 C 3: ATM E3/T3 I
HAPTER
Example

frame-format

Syntax
View
Parameter
Description
Example
C C
NTERFACE ONFIGURATION OMMANDS
Use the undo clock
mode.
# Set the clock mode of ATM E3/T3 interface 5/0 to master.
<Sysname> system-view
[Sysname] interface atm 5/0
[Sysname-Atm5/0] clock master
In ATM E3 interface view:
frame-format { g751-adm | g751-plcp | g832-adm }
In ATM T3 interface view:
frame-format { cbit-adm | cbit-plcp | m23-adm | m23-plcp }
undo frame-format
ATM E3/T3 interface view
g751-adm: Sets the framing format of ATM E3 to G.751 ATM direct mapping
(G.751 ADM).
g751-plcp: Sets the framing format of ATM E3 to G.751 physical layer
convergence protocol (G.751 PLCP).
g832-adm: Sets the framing format of ATM E3 to G.832 ADM.
cbit-adm: Sets the framing format of ATM T3 to C-bit ADM.
cbit-plcp: Sets the framing format of ATM T3 to C-bit PLCP.
m23-adm: Sets the framing format of ATM T3 to M23 ADM.
m23-plcp: Sets the framing format of ATM T3 to M23 PLCP.
Use the
frame-format
E3/T3 interface.
Use the undo frame-format
PLCP for ATM E3 interfaces and C-bit PLCP for ATM T3 interfaces.
# Set the framing format of ATM E3 interface 5/0 to G.832 ADM.
<Sysname> system-view
[Sysname] interface atm 5/0
[Sysname-Atm5/0] frame-format g832-adm
command to restore the default, that is, the slave clock
command to configure the framing format of the ATM
command to restore the default, that is, G.751