148
C
6: ADSL I
HAPTER
display dsl version
Syntax
View
Parameter
Description
Example
C
C
NTERFACE
ONFIGURATION
OMMANDS
Current Rate(kbps):
Latency:
Table 5 Description on the fields of the display dsl status command
Field
Line Status
Training Status
The following information appears after the line is activated.
Active Params
display dsl version interface atm interface-number
Any view
interface-number: Specifies a DSL interface to view the version and support
capability information on it.
Use the
display dsl version
capabilities of an interface.
# Display the ADSL version information of interface ATM 2/0.
<Sysname> display dsl version interface atm 2/0
Adsl board chipset and version info:
0
Intl
Description
Line status of the ADSL interface, which can be:
No Defect, indicating the normal state
■
Loss Of Frame, indicating an error concerning frame
■
Loss Of Signal, indicating an error concerning signal
■
Loss Of Power, indicating an error concerning power supply
■
Loss Of Signal Quality, indicating an error concerning signal quality
■
Unknown, indicating an unknown error
■
Training status of the ADSL interface, which can be:
Idle, indicating the interface is idle
■
G.994 Training, indicating a G.994 training
■
G.992 Started, indicating a G.992 training is launched
■
G.922 Channel Analysis, indicating G.922 channel analysis is going on
■
G.992 Message Exchange, indicating G.992 message exchange is
■
going on
Showtime, indicating normal data exchange
■
Unknown
■
Standard, connection standard adopted by the interface and the
■
DSLAM
SNR, signal-to-noise ration of the ADSL link
■
Attr, attenuation of the ADSL link
■
Pwr, transmit power of the ADSL module, in dbm
■
Current Rate, uplink/downlink rate between the ADSL interface and
■
the DSLAM, in kbps
Latency, Way in which the interface and the DSLAM are connected,
■
which can be "Intl" (cross-over) and "Fast"
command to display the DSL version and support
0
Intl