Display Dsl Configuration - H3C MSR 20-20 Command Reference Manual

132 C 5: G.SHDSL I
HAPTER

display dsl configuration

Syntax
View
Parameter
Description
Example
C C
NTERFACE ONFIGURATION OMMANDS
display dsl configuration interface atm interface-number
Any view
interface-number: Specifies a iG.SHDSL interface to view the configuration
information about.
Use the display dsl configuration
configurations.
# Display the actual configurations of G.SHDSL interface ATM 3/0.
<Sysname> display dsl configuration interface atm 3/0
GSHDSL line parameter and mode Configuration
Mode:
Standard:
Annex:
Wire Type:
Framing:
Line Rate:
Current Margin: 2
SNEXT margin:
Psd Mode:
LinkCheck:
--Actual Handshake Status --
00: 0002 0000 0000 0000 0000 0000 0000 0000 0000 0000
10: 0000 0008 0000 0000 0000 0000 0000 0000 0008 0000
20: 0000 0000 0002 0002 0004 0010
--Local Handshake Status --
00: 0002 0001 0000 0000 0000 0000 0034 003f 003f 003f
10: 003f 003f 0003 0034 003f 003f 003f 003f 003f 0003
20: 0000 0000 0003 0003 000f 0010
--Remote Handshake Status --
00: 0002 0000 0000 0000 0000 0000 0030 003f 003f 003f
10: 003f 000f 0000 0030 003f 003f 003f 003f 000f 0000
20: 0000 0000 0003 0003 0004 0010
Table 1 Description on the fields of the display dsl configuration command
Field
Mode
Standard
Annex
Wire Type
Framing
SNR Threshold
Current Margin
SNEXT margin
command to display actual GSHDSL
CPE
G.991.2
B
2
3
Auto Adaptive
0
Sym PSD
Disable
Description
Operating mode, customer premises equipment (CPE) or
central office (CO)
The supported standard
Available options are a and b.
Two-wire system or four-wire system.
Framing format
Signal to noise ratio threshold
Current margin
Worst-case margin