Display Dsl Status - H3C MSR 20-20 Command Reference Manual

display dsl status

Syntax
View
Parameter
Description
Example
Table 1 Description on the fields of the display dsl configuration command
Field
Target Margin
Line Rate
PSD Mode
Power-Backoff
LinkCheck
Actual Handshake Status
Local Handshake Status
Remote Handshake Status
display dsl status interface atm interface-number
Any view
interface-number: Specifies a G.SHDSL interface to view the status information
about.
Use the
display dsl status
specified G.SHDSL interface.
# Display status information about ATM 5/0, which is a two-wire G.SHDSL
interface that is up.
<Sysname> display dsl status interface atm 5/0
Operating Mode: CPE
DSL Mode: SHDSL Annex B
Configured Wire Type:
Line A Statistics since last activation:
CRC: 0
LOSW Defect: 0
ES: 0
SES: 0
UAS: 0
TX EOC: 0
RX EOC: 0
Line A status:
Xcvr Op State: Data Mode
Last Fail Op State:
Frame Sync:
Line Rate(Kbps):
Wire Type:
SNR Margin(dB): 16.30
Loop Attenuation(dB):
RecvGain(dB):
TxPower(dBm):
Power Backoff: enable
Power Backoff Level:
Tip/Ring Reversal:
FrmOH Stat:
Rmt Encoder A : 0x0000016e
Description
Target margin
Line rate
Power spectral density mode: symmetric or asymmetric
Power compensation
State of link check: enable or disable
--
--
--
command to display status information about the
2
0x00
in sync
2312
2
0.00
6.07
9.50
5
Reversed
0x00
133