Stp No-Agreement-Check; Stp Pathcost-Standard - H3C S7500E Series Command Manual

Command Manual – MSTP
H3C S7500E Series Ethernet Switches

1.1.25 stp no-agreement-check

Syntax
stp no-agreement-check
undo stp no-agreement-check
View
Ethernet interface view, port group view
Parameters
None
Description
Use the stp no-agreement-check command to enable No Agreement Check on the
port(s).
Use the undo stp no-agreement-check command to disable No Agreement Check on
the port(s).
By default, No Agreement Check is disabled.
Note:
The No Agreement Check feature can take effect only on the root port.
Examples
# Enable No Agreement Check on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] stp no-agreement-check

1.1.26 stp pathcost-standard

Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
View
System view
Chapter 1 MSTP Configuration Commands
1-24