Ntp-Service Max-Dynamic-Sessions; Ntp-Service Multicast-Client - H3C MSR 20-20 Command Reference Manual

2308 C 152: NTP C
HAPTER

ntp-service max-dynamic-sessions

Syntax
View
Parameter
Description
Example

ntp-service multicast-client

Syntax
View
Parameter
Description
Example
C
ONFIGURATION OMMANDS
ntp-service max-dynamic-sessions number
undo ntp-service max-dynamic-sessions
System view
number: Maximum number of dynamic NTP sessions to be set up, in the range of
0 to 100.
Use the
ntp-service max-dynamic-sessions
number of dynamic NTP sessions.
Use the
undo ntp-service max-dynamic-sessions
maximum number of dynamic NTP sessions to the system default.
By default, the number is 100.
# Set the maximum number of dynamic NTP sessions to 50.
<Sysname> system-view
[Sysname] ntp-service max-dynamic-sessions 50
ntp-service multicast-client [ ip-address ]
undo ntp-service multicast-client [ ip-address ]
Interface view
ip-address: Multicast IP address, defaulting to 224.0.1.1.
Use the
ntp-service multicast-client
in the NTP multicast client mode.
Use the undo ntp-service multicast-client
an NTP multicast client.
# Configure the device to work in the multicast client mode and receive NTP
multicast messages on Ethernet 1/0, and set the multicast address to 224.0.1.1.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ntp-service multicast-client 224.0.1.1
command to set the maximum
command to restore the
command to configure the device to work
command to remove the device as