Snmp-Agent - H3C MSR 20-20 Command Reference Manual

2336 C 154: SNMP C
HAPTER
Parameter
Description
Related command:
Example

snmp-agent

Syntax
View
Parameter
Description
Example
C
ONFIGURATION OMMANDS
None
Use the enable snmp trap updown
messages for interface state change (linkup/linkdown Trap messages).
Use the
undo enable snmp trap updown
linkup/linkdown SNMP Trap messages on an interface.
By default, the sending of linkup/linkdown SNMP Trap messages is enabled.
Note that:
To enable an interface to send SNMP Trap packets when its state changes, you
need to enable the Link up/down Trap packet transmission function on an
interface and globally. Use the enable snmp trap updown command to enable
this function on an interface, and use the snmp-agent trap enable [ standard
[ linkdown | linkup ] * ] command to enable this function globally.
snmp-agent target-host, snmp-agent trap enable.
#Enable the sending of linkup/linkdown SNMP Trap messages on the port Ethernet
1/0 and use the community name public.
<Sysname> system-view
[Sysname] snmp-agent trap enable
[Sysname] snmp-agent target-host trap address udp-domain 10.1.1.1 pa
rams securityname public
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] enable snmp trap updown
snmp-agent
undo snmp-agent
System view
None
Use the
snmp-agent
Use the
undo snmp-agent
By default, SNMP agent is disabled.
# Disable the current SNMP agent.
<Sysname> system-view
[Sysname] undo snmp-agent
command to enable the sending of Trap
command to enable SNMP agent.
command to disable SNMP agent.
command to disable the sending of