Ntp-Service Unicast-Peer - H3C MSR 20-20 Command Reference Manual

View
Parameter
Description
Example

ntp-service unicast-peer

Syntax
View
Parameter
System view
interface-type interface-number: Specifies an interface by its interface type and
interface number.
Use the
ntp-service source-interface
sending NTP messages.
Use the undo ntp-service source-interface
configured interface for sending NTP messages.
If you do not wish the IP address of a certain interface on the local device to
become the destination address of response messages, you can use this command
to specify a particular interface for sending all NTP messages, so that the source
address in all NTP messages is the primary IP address of this interface.
# Specify that all NTP messages are to be sent out from Ethernet 1/0.
<Sysname> system-view
[Sysname] ntp-service source-interface ethernet 1/0
ntp-service unicast-peer [ vpn-instance vpn-instance-name ] { ip-address |
peer-name } [ authentication-keyid keyid | priority | source-interface interface-type
interface-number | version number ] *
undo ntp-service unicast-peer [ vpn-instance vpn-instance-name ] { ip-address |
peer-name }
System view
vpn-instance vpn-instance-name: Specifies a VPN instance by its name, where
vpn-instance-name is a string of 1 to 31 characters.
ip-address: IP address of the symmetric-passive peer. It must be a host address,
rather than a broadcast address, a multicast address or the IP address of the local
clock.
peer-name: Host name of the symmetric-passive peer, a string of 1 to 20
characters.
authentication-keyid keyid: Specifies the key ID to be used for sending NTP
messages to the peer, where keyid is in the range of 1 to 4294967295.
priority: Specifies the peer designated by ip-address or peer-name as the first
choice under the same condition.
source-interface interface-type interface-number: Specifies an interface for
sending NTP messages. In an NTP message the local device sends to its peer, the
source IP address is the primary IP address of this interface. interface-type
interface-number represents the interface type and number.
command to specify an interface for
command to remove the
2311