Dot1X Max-User - H3C S7500E Series Command Manual

Command Manual – 802.1x - MAC Authentication
H3C S7500E Series Ethernet Switches
Use the undo dot1x handshake command to disable the function.
By default, the function is enabled.
Note that the 802.1x proxy detection function depends on the online user handshake
function. Be sure to enable handshake before enabling proxy detection and to disable
proxy detection before disabling handshake.
Examples
# Enable online user handshake.
<Sysname> system-view
[Sysname] interface Ethernet2/0/4
[Sysname-Ethernet2/0/4] dot1x handshake

1.1.6 dot1x max-user

Syntax
In system view:
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
In Ethernet interface view:
dot1x max-user user-number
undo dot1x max-user
View
System view, Ethernet interface view
Parameters
user-number: Maximum number of users to be supported simultaneously. The valid
range is from 1 to 1024.
interface interface-list: Specifies an Ethernet port list, which can contain multiple
Ethernet ports. The interface-list argument is in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] } & <1-10>,
where interface-type represents the port type, interface-number represents the port
number, and & <1-10> means that you can provide up to 10 port indexes/port index lists
for this argument. The start port number must be smaller than the end number and the
two ports must of the same type.
Description
Use the dot1x max-user command to set the maximum number of users to be
supported simultaneously for specified or all ports.
Use the undo dot1x max-user command to restore the default.
Chapter 1 802.1x Configuration Commands
1-9