Ntp-Service In-Interface Disable - H3C MSR 20-20 Command Reference Manual

Description
Example

ntp-service in-interface disable

Syntax
View
Parameters
Description
Examples
version number: Specifies the NTP version, where number is in the range of 1 to 3
and defaults to 3.
Use the
ntp-service broadcast-server
work in the NTP broadcast server mode.
Use the
undo ntp-service broadcast-server
as an NTP broadcast server.
# Configure the device to work in the broadcast server mode and send NTP
broadcast messages on Ethernet 1/0, using key 4 for encryption, and set the NTP
version to 3.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ntp-service broadcast-server authentication-ke
yid 4 version 3
ntp-service in-interface disable
undo ntp-service in-interface disable
Interface view
None
Use the
ntp-service in-interface disable
from receiving NTP messages.
Use the undo ntp-service in-interface disable
default.
By default, all interfaces are enabled to receive NTP messages.
On an Ethernet interface:
■
# Disable interface Ethernet 1/0 from receiving NTP messages.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ntp-service in-interface disable
On a VLAN interface:
■
# Disable VLAN-interface 1 from receiving NTP messages.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ntp-service in-interface disable
command to configure the device to
command to remove the device
command to disable an interface
command to restore the
2307