Command-Privilege - H3C MSR 20-20 Command Reference Manual

Related command:
Example

command-privilege

Syntax
View
Parameter
Description
After the configuration takes effect, use the display clock command to view the
result. The information such as log file and debug adopts the local time modified
by time-zone and daylight saving time.
clock datetime, clock summer-time one-off, clock summer-time repeating,
display clock.
# Set the name of the local time zone to Z5, five hours ahead of UTC time.
<Sysname> clock timezone z5 add 5
command-privilege level level view view command
undo command-privilege view view command
System view
level level: Specifies a command level in the range 0 to 3.
view view: Specifies a view.
command: Command to be set in the specified view.
Use the command-privilege
the specified view.
Use the
undo command-privilege view
By default, the commands under each view have their respective command levels.
Generally, do not modify the default command levels to avoid inconvenience to
your maintenance and operation.
Command privilege falls into four levels: visit, monitor, system, and manage,
which are identified by 0 through 3.
The administrator can assign a privilege level for a user according to his need.
When the user logs on a device, the commands available depend on the user's
privilege. For example, if a user's privilege is 3 and the command privilege of VTY 0
user interface is 1, and the user logs on the system from VTY 0, he can use all the
commands with privilege smaller than three (inclusive).
The following table describes the default level of the commands.
Table 622 Default level of the commands
Command level
Visit (0)
Monitor (1)
System (2)
command to assign a level for the commands in
command to restore the default.
Commands
ping, tracert, telnet
refresh, reset, send
Configuration commands
2409