Table of Contents
Advertisement
RIP C
OMMANDS
-
IP RIP RECEIVE
PACKET
ip rip receive-packet
Overview
Use this command to configure the interface to enable the reception of RIP
packets.
Use the no variant of this command to disable this feature.
Syntax
ip rip receive-packet
no ip rip receive-packet
Default
Receive-packet is enabled
Mode
Interface Configuration for a VLAN interface.
Usage
This command can only be configured on VLAN interfaces.
Example
This example shows packet receiving being turned on for the VLAN interface
vlan3:
awplus#
awplus(config)#
awplus(config-if)#
Related
ip rip send-packet
Commands
C613-50103-01 REV A
configure terminal
interface vlan3
ip rip receive-packet
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
802
Advertisement
Table of Contents
