Ip Rip Receive-Packet - Allied Telesis AT-x510-28GTX Command Reference Manual

RIP C
OMMANDS
-
IP RIP RECEIVE PACKET

ip rip receive-packet

Overview Use this command to configure the interface to enable the reception of RIP
packets.
Use the no variant of this command to disable this feature.
Syntax ip rip receive-packet
no ip rip receive-packet
Default Receive-packet is enabled
Mode Interface Configuration for a VLAN interface.
Usage This command can only be configured on VLAN interfaces.
Example This example shows packet receiving being turned on for the VLAN interface
vlan3:
awplus#
awplus(config)#
awplus(config-if)#
Related ip rip send-packet
Commands
C613-50102-01 REV C
configure terminal
interface vlan3
ip rip receive-packet
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
833