Ip Rip Receive-Packet - Allied Telesis IE340 Series Command Reference Manual

RIP C
OMMANDS
-
IP RIP RECEIVE PACKET

ip rip receive-packet

Overview Use this command to configure the interface to enable the reception of RIP
packets.
Use the no variant of this command to disable this feature.
Syntax ip rip receive-packet
no ip rip receive-packet
Default Enabled
Mode Interface Configuration for a VLAN interface.
Example To turn on packet receiving on the interface vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ip rip send-packet
commands
C613-50631-01 Rev A
configure terminal
interface vlan2
ip rip receive-packet
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
1042