Ppp Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
PPP I
NTERFACE
To create a virtual Point-to-Point Protocol (PPP) interface and/or activate the PPP Interface Configuration
mode, enter the interface ppp command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface ppp 1
(config-ppp 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
acfc accept-compressed on page 2465
alias link "<text>" on page 2466
bandwidth <value> on page 2467
bridge-group commands begin on page 2468
crypto map <name> on page 2470
dial-backup commands begin on page 2472
dynamic-dns on page 2488
fair-queue on page 2490
hold-queue <value> out on page 2491
ip commands begin on page 2492
ipv6 commands begin on page 2533
keepalive <value> on page 2561
lldp receive on page 2562
lldp send on page 2563
max-reserved-bandwidth <value> on page 2565
media-gateway ip on page 2566
peer default ip address <ipv4 address> on page 2567
peer default ipv6 interface-id <interface id> on page 2568
ppp commands begin on page 2569
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

PPP Interface Command Set

2463