Table of Contents
Advertisement
Command Reference Guide
switchport trunk fixed vlan
Use the switchport trunk fixed vlan command to change the configured list of virtual local area networks
(VLANs) that remain fixed in use only when GARP VLAN Registration Protocol (GVRP) is enabled on
the interface. Of these VLANs, VLANs statically or dynamically created will be available for use on the
interface. Use the no form of this command to return to the default setting. Variations of this command
include:
switchport trunk fixed vlan <list>
switchport trunk fixed vlan add <list>
switchport trunk fixed vlan all
switchport trunk fixed vlan except <list>
switchport trunk fixed vlan none
switchport trunk fixed vlan remove <list>
Syntax Description
add
all
except
none
remove
<list>
Default Values
By default, no VLANs are in the VLAN GVRP trunking fixed list (switchport trunk fixed vlan none).
Command History
Release 8.1
Functional Notes
This command has no effect on VLAN membership configuration unless GVRP is enabled on the interface.
Refer to
gvrp on page 954
A VLAN list is a set of VLAN IDs. A valid VLAN ID value must be from 1 to 4094 (inclusive). Each VLAN ID
in a list is delimited by commas, yet a range of IDs may be expressed as a single element by using a
hyphen between endpoints. For example, the VLAN ID range 1,2,3,4,6,7,8,9,500 may be more easily
expressed as 1-4,6-9,500. No spaces are allowed in a valid ID range.
60000CRG0-35E
Adds VLANs to the VLAN GVRP trunking fixed list.
Adds all VLANs to the VLAN GVRP trunking fixed list.
Adds all VLAN IDs to the VLAN trunking fixed list except those in the
command line VLAN ID list.
Removes all VLANs from the VLAN GVRP trunking fixed list.
Removes VLAN from the VLAN trunking fixed list.
Specifies a list of valid VLAN interface IDs. Refer to Functional Notes below
for additional syntax considerations.
Command was introduced.
for information on enabling GVRP.
Copyright © 2012 ADTRAN, Inc.
Port Channel Interface Command Set
2460
Advertisement
Table of Contents
