Ethoam Loopback - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Ethernet OAM Commands

ethoam loopback

Enables the maintenance entity to initiate transmitting loopback messages (LBMs) and obtaining loop-
back replies.
ethoam loopback {target-macaddress mac_address | target-endpoint tar_mep_id} source-endpoint
src_mep_id domain {domain_name | mac_address} association association_name [number
number_of_messages] [data data_size] [vlan-priority vlan_priority] [drop-eligible {true | false}]
Syntax Definitions
mac_address
tar_mep_id
src_mep_id
domain_name
domain mac_address
association_name
number_of_messages
data_size
vlan_priority
true
false
Defaults
parameter
number_of_messages
true | false
Platforms Supported
OmniSwitch 6250-Metro Models
OmniSwitch 6250 CLI Reference Guide
Target MAC address to be transmitted.
Specifies the MEP for which the Loopback message is targeted.
Specifies the MEP that transmits the Loopback message. The valid
range is 1–8191.
Specifies the domain name. For more information on the different
formats of the domain name, refer to
page 25-3.
Specifies the CFM system MAC address.
Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
Specifies the number of loopback messages to be transmitted. The range
is 1–16.
Specifies the amount of data to be included in the Data Type Length
Value (TLV), if the Data TLV is selected to be sent. The valid range is
1–255.
Specifies the 3-bit value to be used in the VLAN tag, if present in the
transmitted frame. The valid range is 0–7.
Sets the drop eligibility bit in the VLAN tag to true.
Sets the drop eligibility bit in the VLAN tag to false.
default
1
true
November 2009
ethoam domain command on
page 25-27