Ethoam Linktrace - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

Ethernet OAM Commands

ethoam linktrace

Enables the maintenance entity to initiate transmitting Link Trace Messages (LTM).

ethoam linktrace {target-macaddress mac_address | target-endpoint tar_mep_id} source-endpoint

src_mep_id domain {domain_name | mac_address} association association_name [flag fdbonly] [hop-

count hop_count]

Syntax Definitions

domain mac_address

association_name

Platforms Supported

OmniSwitch 6250-Metro Models

Usage Guidelines

This command allows an operator to generate a LTM for the specified MEP.

This command signals the MEP that it should transmit a Linktrace message and detect the presence or

lack of the corresponding Linktrace messages.

OmniSwitch 6250 CLI Reference Guide

Target MAC address to be transmitted.

Specifies the MEP for which the Loopback message is targeted.

Specifies the MEP that transmits the Loopback message. The valid

range is 1–8191.

Specifies the domain name. For more information on the different

formats of the domain name, refer to

Specifies the CFM system MAC address.

Name of the Ethernet OAM Association. Up to 48 (minus the domain

name length) characters may be used.

Specifies that only the MAC addresses learned in a bridge's active data

forwarding table will be used to decide the egress port.

Indicates the number of hops remaining in this LTM. Each bridge that

handles the LTM decreases the value by 1. This decreased value is

returned to the LTM. The valid range is 1–2^32.

November 2009

ethoam domain command on