Reset Dot1X Statistics - H3C S5120-SI Series Command Reference Manual

Server timeout timer (server-timeout): Once the device sends a RADIUS Access-Request packet
to the authentication server, it starts this timer. If this timer expires but it receives no response from
the server, it retransmits the request.
Client timeout timer (supp-timeout): Once the device sends an EAP-Request/MD5 Challenge
packet to a client, it starts this timer. If this timer expires but it receives no response from the client,
it retransmits the request.
Username request timeout timer (tx-period): Once the device sends an EAP-Request/Identity
packet to a client, it starts this timer. If this timer expires but it receives no response from the client,
it retransmits the request. In addition, to be compatible with clients that do not send EAPOL-Start
requests unsolicitedly, the device multicasts EAP-Request/Identity packet periodically to detect the
clients, with the multicast interval defined by tx-period.
It is unnecessary to change the timers unless in some special or extreme network environments. The
change of a timer takes effect immediately.
Related commands: display dot1x.
Examples
# Set the server timeout timer to 150 seconds.
<Sysname> system-view
[Sysname] dot1x timer server-timeout 150

reset dot1x statistics

Syntax
reset dot1x statistics [ interface interface-list ]
View
User view
Default Level
2: System level
Parameters
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1-10>, where interface-type represents the port type,
interface-number represents the port number, and & <1-10> means that you can provide up to 10 port
indexes/port index lists for this argument. The start port number must be smaller than the end number
and the two ports must be of the same type.
Description
Use the reset dot1x statistics command to clear 802.1X statistics.
With the interface interface-list argument specified, the command clears 802.1X statistics on the
specified ports. With the argument unspecified, the command clears global 802.1X statistics and
802.1X statistics on all ports.
Related commands: display dot1x.
1-17