Pppoe-Client Wait-For-Ipcp - Avaya G450 Cli Reference Manual

CLI Commands

pppoe-client wait-for-ipcp

Use the pppoe-client wait-for-ipcp command to configure the amount of time
between PPPoE tunnel establishment and IPCP tunnel establishment. The PPPoE client
terminates the PPPoE tunnel if this time is exceeded. Use the no form of this command to
restore the default value, which is 20 seconds.
Note:
The PPP stack has a somewhat similar command: ppp timeout ncp.
Note:
However while this command only terminates the LCP, the pppoe-client
wait-for-ipcp command terminates the PPPoE tunnel.
Syntax
[no] pppoe-client wait-for-ipcp seconds
Parameters
Parameter
seconds
User Level
read-write
Context
interface:FastEthernet
Example
To configure the amount of time between PPPoE tunnel establishment and IPCP tunnel
establishment as 30 seconds:
G450-001(super-if:FastEthernet 10/2)# pppoe-client wait-for-ipcp 30
Related Commands
encapsulation
pppoe-client persistent
show ppp authentication
830 Avaya G450 CLI Reference
Description
The number of seconds to wait
pppoe, mtu, ppp chap
delay, pppoe-client persistent
hostname, ppp chap password,
max-attempts,
PPPoE (PPP over Ethernet)
Possible Default
Values Value
5-10000 20
ppp pap sent-username,
pppoe-client service-name,