Distance (Rip) - Allied Telesis x310-26FT Command Reference Manual

RIP C
OMMANDS
(RIP)
DISTANCE

distance (RIP)

Overview This command sets the administrative distance for RIP routes. Your device uses this
value to select between two or more routes to the same destination obtained from
two different routing protocols. The route with the smallest administrative
distance value is added to the Forwarding Information Base (FIB). For more
information, see the
The no variant of this command sets the administrative distance for the RIP route
to the default of 120.
distance <1-255> [<ip-addr/prefix-length> [<access-list>]]
Syntax
no distance [<1-255>] [<ip-addr/prefix-length> [<access-list>]]
Mode RIP Router Configuration
To set the administrative distance to 8 for the RIP routes within the 10.0.0.0/8
Examples
network that match the access-list mylist, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
To set the administrative distance to the default of 120 for the RIP routes within
the 10.0.0.0/8 network that match the access-list mylist, use the
commands:
awplus#
awplus(config)#
awplus(config-router)#
C613-50103-01 REV A
Route Selection Feature Overview and Configuration
Parameter Description
<1-255>
The administrative distance value you are setting for this RIP
route.
<ip-addr/
The network IP address and prefix-length that you are changing
prefix-length>
the administrative distance for.
<access-list>
Specifies the access-list name. This access list specifies which
routes within the network <ip-address/m>this command
applies to.
configure terminal
router rip
configure terminal
router rip
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
distance 8 10.0.0.0/8 mylist
no distance 8 10.0.0.0/8 mylist
Guide.
792