Display Ipc Queue - H3C SR6600 Command Reference Manual

regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
If IPC performance statistics is enabled, the command displays the current IPC performance statistics. If
IPC performance statistics is disabled, the command displays the IPC performance statistics collected
before IPC performance statistics was disabled.
Examples
# Display the IPC performance statistics for node 6.
<Sysname> display ipc performance node 6
Peak: Peak rate (pps)
10Sec: Average rate in the last 10 seconds (pps)
1Min: Average rate in the last 1
5Min: Average rate in the last 5
Total-Data: Total number of data (packets)
Statistics for packets sent successfully:
Peak
------------------------------------------------------------
1
Statistics for packets received successfully:
Peak
------------------------------------------------------------
1
Statistics for packets acknowledged:
Peak
------------------------------------------------------------
1
Table 20 Command output
Field
Peak
10Sec
1Min
5Min
Total-Data
Related commands
ipc performance enable

display ipc queue

Use display ipc queue to display output queue information for the specified node.
10Sec 1Min
1 1
10Sec 1Min
1 1
10Sec 1Min
1 1
minute (pps)
minutes (pps)
5Min Total-Data
0
5Min Total-Data
0
5Min Total-Data
0
Description
Peak rate in pps (average rate is computed every 10 seconds,
and the greatest average rate is taken as the peak rate).
Average rate (in pps) in the last 10 seconds.
Average rate (in pps) in the last 1 minute.
Average rate (in pps) in the last 5 minutes.
Total amount of data collected from the time when IPC
performance statistics was enabled to the time when this
command is executed.
93
80
82
78