Queue-Limit - Avaya G450 Cli Reference Manual

CLI Commands

queue-limit

Use the queue-limit command to set the packet size of any of the four priority queues. Use
the no form of the command to restore the packet sizes of the queues to their default values,
using the interface bandwidth.
Note:
The queue-limit command is only applicable if priority queueing mode is
Note:
enabled.
Syntax
queue-limit queue_id size
no queue-limit
Parameters
Parameter
queue_id
size
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L2, USP PPP L2, USP PPP L2-L3), FastEthernet
(L2, L2-L3) - when Frame Relay Traffic Shaping is configured, Serial (DS1 FR L2, USP FR L2) -
when Frame Relay Traffic Shaping is not configured, Dialer (L2, L2-L3)
Example
To specify a size of 200 for queue 1:
G450-001(if:Serial 3/1:1)# queue-limit 1 200
Related Commands
priority-queue,
832 Avaya G450 CLI Reference
Description
The queue priority ID
The size of the queue, in packets
show queueing, voip-queue,
Possible Values
1 (highest)
4 (lowest)
The total number
of packets in all
queues cannot
exceed 5000
voip-queue-delay
Priority queueing
Default
Value