Priority Queueing; Priority-Queue - Avaya G450 Cli Reference Manual

Priority queueing

priority-queue

Use the priority-queue command to enable priority queueing mode in a Serial or
FastEthernet interface. By default, priority queueing is off, and WFVQ is enabled on all Serial
interfaces and all FastEthernet interfaces for which traffic-shaping is enabled. If you disable
priority queueing by using the no form of the priority-queue command, WFVQ is
re-enabled.
Syntax
[no] priority-queue
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L2, USP PPP L2, USP PPP L2-L3), FastEthernet
(L2, L2-L3) - when Frame Relay Traffic Shaping is configured, Serial (DS1 FR L2, USP FR L2) -
when Frame Relay Traffic Shaping is not configured, Dialer (L2, L2-L3)
Example
To enable priority queueing:
G450-001(if:Serial 3/1:1)# priority-queue
Related Commands - Priority queueing
queue-limit, show
Related Commands - WFVQ
fair-queue-limit, fair-voip-queue, priority-queue,
voip-queue
queueing, voip-queue, voip-queue-delay
show queue, show
Priority queueing
queueing, voip-queue,
Issue 1 January 2008 831