Idle-Character - Avaya G450 Cli Reference Manual

CLI Commands
Example
To manually set the bandwidth for the VLAN interface to 100 KB/s:
G450-001(if:Vlan 1)# bandwidth 100
Related Commands

idle-character,

idle-character
Use the idle-character command to set the bit pattern used to indicate an idle line. Use the
no form of this command to restore the default value. For E1 and USP interfaces, the default
value is flags. For T1 interfaces, the default is marks.
Syntax
idle-character {flags|marks}
no idle-character
Parameters
Parameter
flags
marks
User Level
read-write
Context
interface:Serial (DS1 PPP L2, DS1 PPP L2-L3, DS1 FR L2, USP PPP L2, USP PPP L2-L3,
USP FR L2)
Example
To set the idle-character to marks:
G450-001(if:Serial 3/1)# idle-character marks
1170 Avaya G450 CLI Reference
ignore dcd, interface serial,
Description
Keyword specifying that flags are
transmitted to indicate an idle line
Keyword specifying that marks are
transmitted to indicate an idle line
invert txclock, nrzi-encoding,
USP configuration
transmitter-delay
Possible Default
Values Value