Efm-Oam Port Remote-Loopback - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

LINK OAM Commands

efm-oam port remote-loopback

Specifies whether loopback requests from peers are processed or ignored on the specified port.

efm-oam port slot/port[-port2] remote-loopback {process | ignore}

Syntax Definitions

By default, the incoming loopback requests are ignored.

Platforms Supported

OmniSwitch 6250.

Usage Guidelines

When the remote-loopback is in process mode, the session started by peer LINK OAM client will be

processed by local LINK OAM port. As a result, remote port will be in remote-loopback state and the

local port will be local-loopback state.

When the remote-loopback is in ignore mode, the session started by peer LINK OAM will not be

processed by the local port.

-> efm-oam port 1/1 remote-loopback process

-> efm-oam port 1/1 remote-loopback ignore

-> efm-oam port 2/1-10 remote-loopback process

-> efm-oam port 2/1-4 remote-loopback ignore

Release History

Release 6.6.1; command was introduced.

OmniSwitch 6250 CLI Reference Guide

The slot number for the module and the physical port number on that

module (e.g. 3/1 specifies port 1 on slot 3).

Specifies the last port in the range of ports.

Processes incoming loopback request from peer LINK OAM port.

Ignore (discard) incoming loopback requests.

November 2009