Show Ntp Peers - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ntp peers

Displays the information about the current status on the NTP peer association.
show ntp peers
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Use this command to display the tabular information on the current NTP peer association status.
Examples
-> show ntp peers
IP Address
--------------+------+-----+-----+----------+--------------+--------------
172.23.0.202
10.255.24.120
output definitions
IP Address
Ver
Key
St
Delay
Offset
Disp
Release History
Release 6.4.2; command was introduced.
page 56-36
Ver Key St
4 0 3
4 0 3
Peer IP Address
The version of NTP the server is using. Versions 3 and 4 are valid.
The NTP server's public key. This must be accurate and the same as the
NTP server or the client switch will not be able to synchronize with the
NTP server. A zero (0) means there is no key entered.
The stratum of the server.
The delay received from the server in its timestamp.
The offset received from the server in its timestamp.
The dispersion value received from the server in its timestamp.
Delay Offset
0.300 0.404
0.016 0.250
OmniSwitch CLI Reference Guide
Network Time Protocol Commands
Disp
0.0024
0.0017
June 2012