Show Ntp Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ntp status

Displays the information about the current NTP status.
show ntp status
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command displays the information about the status of NTP, which is configured along with other
global configuration. See the Examples section for more information.
•
If the source IP Configuration is done in default or no-loopback0 then the source ip-address will not be
displayed in the output of the
Example
-> show ntp status
Current time
Last NTP update
Server reference:
Client mode
Broadcast client mode
Broadcast mode delay (microseconds)
Server qualification
Stratum
Max-Associations
Authentication
Source IP Configuration
Source IP
output definitions
Current time
Last NTP update
Client mode
Broadcast client mode
Broadcast delay
page 56-22
show ntp status command.
: Tue APR 29 2003
: Tue APR 29 2003
: 0.0.0.0,
: enabled,
: disabled,
: 4000,
: synchronized,
: 16,
: 32,
: disabled,
: Preferred,
: 10.145.15.15
The current time for the NTP client.
The time of the last synchronization with an NTP server.
Whether the NTP client software is enabled or disabled.
What NTP mode the client is running in, either client or broadcast.
The number of microseconds in the advertised broadcast delay time.
This field is absent if the client broadcast mode is disabled.
Network Time Protocol Commands
18:48:01 (UTC),
18:44:15 (UTC),
OmniSwitch CLI Reference Guide June 2012