Show Ntp Client - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ntp client

Displays information about the current client NTP configuration.
show ntp client
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
This command displays the current configuration parameters for the NTP client. The display is slightly
different depending on what has been configured on the client. See the Examples section for more infor-
mation.
Examples
-> show ntp client
Current time
Last NTP update
Client mode
Broadcast client mode
Broadcast delay (microseconds): 4000
output definitions
Current time
Last NTP update
Client mode
Broadcast client mode
Broadcast delay
Server Qualification
Release History
Release 6.1; command was introduced.
page 56-24
: SAT APR 16 2005 00:19:02 (UTC)
: SAT APR 16 2005 00:06:45 (UTC)
: enabled
: disabled
The current time for the NTP client.
The time of the last synchronization with an NTP server.
Whether the NTP client software is enabled or disabled.
What NTP mode the client is running in, either client or broadcast.
The number of microseconds in the advertised broadcast delay time.
This field is absent if the client broadcast mode is disabled.
Indicates whether they server must be synchronized or not.
Network Time Protocol Commands
OmniSwitch CLI Reference Guide June 2012