Changing The Mch Module's Ip Address - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00

Changing the MCH module's IP Address

This procedure shows how to connect to the MicroTCA Carrier Hub (MCH) module, and
issue commands to configuring the MCH's IP Address settings.
This procedure does not apply if your MPA unit has an SCM-210 card.
Communication to the MCH module can be via an Ethernet (Telnet) connection to the
MCH's GbE Ethernet port (Option 1), or via a USB (Serial) connection to the MCH's
micro-USB port (Option 2).
Note: After establishing a connection to the MCH card via either of the two options, then
you can View the MCH current IP Address, or Change the MCH IP Address.
Software Requirements
•
For Ethernet, any Telnet client application software, such as PuTTY
•
For USB, the nat_mch.inf driver file (included in USB flash drive, and available
upon request), and any Serial port terminal software, such as PuTTY
(PuTTY is included on the USB flash drive shipped with the MPA system, or can
be downloaded free from
Hardware Requirements
•
A Personal Computer
)
http://www.putty.org/
Configuring the IP Address
28