Mpm Test Module Cards And Slot Locations - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00
Getting Started
This image shows two MPM-10G cards, for a total of four independent 10G Test
Units.
"Test Unit #1" and "Test Unit #2" belong to the MPM-10G card in Slot #1.
•
The OTN, SDH and PACKET Protocol Processor tabs for Test Unit #1 are
labelled as "S1-P1", which is short for Slot #1 and Port #1.
•
The OTN, SDH and PACKET Protocol Processor tabs for Test Unit #2 are
labelled as "S1-P2", which is short for Slot #1 and Port #2.
"Test Unit #3" and "Test Unit #4" belonging to MPM-10G card in Slot #2.
•
The OTN, SDH and PACKET Protocol Processor tabs for Test Unit #3 are
labelled as "S2-P1", which is short for Slot #2 and Port #1.
• The OTN, SDH and PACKET Protocol Processor tabs for Test Unit #4 are
labelled as "S2-P2", which is short for Slot #2 and Port #2.

MPM Test Module Cards and Slot Locations

There are currently three generations of the
unique MPM test module slot locations.
Gen 1 and Gen 2 MPA systems include an MCH and an AMC Processor
(AM4022 ), and support a maximum of five (5) single-slot MPM test
modules.
Gen 3 MPA systems include an SCM-210 card, and support a maximum of
six (6) single-slot MPM test modules.
75
MPA chassis design, each with