VeEX MPA User Manual page 535

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
A packet stream's profile defines the type, size, content, destination address, and
source addresses for the frame.
The stream protocol supported is UDP/IP.
The Traffic Stream Profile dialog box is used to set the stream profile parameters. To
access this dialog box, select any of the streams in the Stream Profile Table.
Parameter
Stream ID #
Multi Stream Config
MAC Src address
535
Description
Displays the Stream ID # that the settings are being modified for.
The title bar of this Traffic Stream Profile window also shows
which Stream ID # is currently selected.
Automatically increments the Source and Destination IP and
MAC address values on up to all 32 Streams, and applies other
global changes to each selected Stream, all in one step. See
Ethernet Multi-Stream Configuration
Important: Multi-Stream Configuration is only available when
the processor is licensed for the Advanced Ethernet test option,
enabling up to 32 independent test streams per port. Otherwise,
this feature is unavailable when only 1 test stream is enabled.
Multi-Stream Configuration is not supported on the MPM-400G
card, which currently supports a single test stream.
Sets a Source MAC (origination) address for generated traffic.
The address is a 12-digit (6-octets) HEX value that is entered
using a keypad. The address is entered into 6 separate fields, 2
characters each. There are no restrictions on value entered but
all a value must be entered in all fields.
for details.