VeEX MPA User Manual page 551

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
Trial Duration
BW Ceiling
Dest MAC
Address
Dest Port
BW Floor
Packet Size
buttons
Statistics Table
551
Displays how long the test will run for each packet size. This
duration is used each time the test fails.
The Trial Duration
screen.
Displays the setting for the high-end of the bandwidth test
range.
The BW Ceiling is configured from the RFC Tests - Conf
screen.
Displays the destination MAC address of the device that will
receive the RFC test.
The Dest MAC Address
Stream ID from the Traffic Stream Profile on the Conf screen.
Displays the destination port that will receive the test signal.
The destination port configuration setting is not supported
on the MPA.
Displays the setting for the low-end of the bandwidth test
range.
The BW Floor is configured from the RFC Tests - Conf
screen.
Determines which packet size results appear in the statistics
table. Selecting a packet size button displays its results.
Displays the frame loss test results for a specified packet
size. The results display the nine rates determined by the BW
Ceiling and BW Floor settings. The following statistics are
displayed:
Rate % - Indicates the percentage of bandwidth transmitted
using the bandwidth ceiling and floor settings.
Transmit Frames - Reports the total number of frames
transmitted.
Receive Frames - Reports the total number of frames
received.
Loss % - Reports the percentage of frame loss that occurred
during the test. This calculation is the received frames divided
is configured from the RFC Tests - Conf
is configured for the selected