MPA_e_manual_D07-00-129P_RevA00
•
Power Hot, Power Warm and Power Low Alarms
•
Using M.2120 / M.2110 PM
•
Insert Alarms
•
Insert Errors
•
Make Pointer Adjustments
•
Use the Event Log
•
Saving and Printing Statistics and Settings Reports
SDH Troubleshooting
SDH Troubleshooting Overview
This section provides a brief summary of conditions that can cause SDH errors and
alarms:
•
Unit reports Loss of Signal (LOS)
•
What causes a B1 error?
•
What causes a B2 error?
•
What causes a B3 error?
•
What causes an AIS alarm?
•
What causes an RDI alarm?
•
How to Insert Errors
•
How to Insert Alarms
Unit Reports Loss of Signal
A Loss of Signal (LOS) occurs when the unit detects an all-zeros pattern for 100
milliseconds or greater on the incoming SDH signal.
If an LOS is present, verify the receive signal strength as indicated by RX in the
LEDs/Quick Status area of the touch screen.
Refer to the
SFP Info
screen for minimum RX power level.
SDH Tab
502