VeEX MPA User Manual page 387

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
1. Select a protocol processor mode.
2. Select Transmit and choose PTR.
3. Configure the Pointer Value parameters. For example,
•
Select
value has been transmitted.
•
Select
•
Select
adjustments.
4. Configure the Pointer Sequence parameters. For example,
•
Select
occurs when the Increment Pointer or Decrement Pointer buttons are
selected.
•
Use
(ranging from 1 to 8) to occur when the Inc Pointer or Dec Pointer
buttons are pressed.
•
Use
pointer adjustments, from 5.5 ms to 35 seconds.
4. Select INC Pointer
to make a negative pointer adjustment.
These buttons generate and control Pointer movements within the transmitted signal.
You can stress test a network by changing pointers or introducing an offset that
continuously adjusts the STS or VT Pointer.
Recording in the Event Log
The Event Log is a table that displays events recorded by the unit. A scroll bar is
available, allowing you to scroll up and down to view an extended history.
To use the Event Log:
1. Select a protocol processor tab.
2. Select the Results button.
3. Select Event. As events occur (such as alarms, errors, or Pointer activity) they
appear and continuously scroll in the table.
Events display in a ascending order from the most recent event to the oldest
event. The Descending button indicates that events appear in descending order.
(This button switches between descending event order appearance and
ascending event order appearance. The current label of the button indicates the
event order.)
4. To begin a new test, select the
the touch screen. This will clear all history of previous events, and resets the
Start Test Date and Time stamp to current time. You now have a reference
point as to when new events occur, in comparison to when the test began.
387
NDF Flag to allow a New Data Flag to be set when a new Pointer
Pointer Value to change the Pointer value from 0 to 782.
Frequency Offset
Pointer Action to select the type of Pointer Sequence activity that
Burst Count to set the number of Pointer location movements
Ms between Bursts to configure the time-interval between sequential
to make a positive pointer adjustment, or select
Restart
to increase or decrease the speed of the Pointer
function button located at the bottom of
DEC Pointer